Prerequisites

Hardware

  • 30 V Psu ( Step up can be used from either 12V or 24V PSU as we only want to drive 2 Step sticks of it )
  • Rigid Z couplings
  • Anti backlash TR Nuts
  • Fiberglass reinforced belts
  • 20 Tooth / 5 mm bore pulleys / Idlers
  • Direct Extruder ( Preferably E3D Titan or similar )
  • TMC 2100 / 2130 Step stick x 2
  • Multiple 40mm Fans, one for every stepper mounted to plastic, atleast two for ramps, rumba, whatever.
  • Pertinax ( Hartpapier ) Sheet as printing surface
  • Fiberglass insulation for the bottom of the heatbed
  • Light bed bearing holders
  • Light extruder holder

 

Software

  • Octoprint
  • S3D

Firmware:

  • Klipper
  • Smoothieware

Leave a Reply

Your email address will not be published. Required fields are marked *